accent pillow case baby burlap housewarming gift Bra Making- How To Sew A Hook and Eye decorative pillow shams
You’ve almost completed sewing a bra—all you have left to do is attach the hook and eye. Even though the finish line is in site， a lot can go wrong in the final step. Ask me how I know! Below， I share with you my tried and true method， including a few tips and tricks， to？make completing that beautiful bra come sooner rather than later.
Before I get started， there are two types of hooks and eyes most commonly used for bra making. The first is a continuous length that can be bought by the yard or by the meter.？The tape is？trimmed to fit the length of the center back and needs no finishing， but I？prefer to？zig-zag？the top and bottom edges. The second is a precut lengthaccent pillow case baby burlap housewarming gift， usually 1×3， 2×3， 3×3 or 4×3. I use this type the most because it is？heat sealed along the top and bottom edges so it？won’t fray or look ragged after it is？washed (do not put your bras in the dryer!). Which precut hook and eye you choose depends on the height/length？of the center back. A 2 x 3 hook and eye measures 1.5″； high， so your center back must measure the same in order for it to fit. A 3 x 3 hook and eye measure 1.875″； high， so again， your center back must measure？the same.personalized toys
You can attach either the left or right side first— it doesn’t matter—but the eyes always go on the left side. An easy way to remember this is the word eyes has 4 letters， and the word left has 4 letters.
Open tape of the eyes and spray adhesive to the inside (or use a glue stick to apply a light layer). The glue？is super helpful with keeping everything in place while sewing and way better than using pins (I rarely use pins for bra making).
Next， wrap the eye over the raw edge， press in place， and then sew using a straight stitch 1/8” from the tape’s edge. I switch needles at this step， from a ballpoint to a universal. Because a hook and eye is super think and doesn’；t contain spandex or lycra like the rest of the bra， I use a different needle or else I’；ll get skipped stitches. I don’；t use a special machine setting at this step， nor do I use a special presser foot. For this tutorial， I am using BERNINA’；s Reverse pattern foot 1C， which is an all？purpose foot that works well for forward-feed and multi-motion stitches.
For the hook side， I open the tape， apply adhesive/glue，？wrap the tape around the edge， and sew 1/8” from edge tape’；s edge with a straight stitch just like I did for the eye side. For this step， you MUST sew with？the hooks facing up (see photo above).？You can’；t sew with the hooks facing down as it will damage your machine. Also note that I change the position of the needle to be all the way to the right so the needle is 1/8″； from the edge. Just like step 2， I use an all purpose presser foot to sew.
See， isn’；t that easy？ I told you so!
Read more details about this bra on my blog， Madalynne.
Tie dye is back, well it would be fair to say that it never really went out of fashion. It may have taken a back seat in interior design over the last few years, but like any good design it reappears or in the case of tie dye 'bursts' back onto the scene and this year is one of those years!